Replacement Auger Motor for Pit Boss 2 RPM Series

Instructions:

• Unplug your unit from the power supply
• Remove the service door under the hopper
• Disconnect the wires of the temperature probe, igniter, fan and motor respectively
• Remove the setting screw for the ground wire, and then unplug the power cord from the bracket
• Remove four screws in front and back of hopper, and then remove the hopper completely
• Remove the screws and auger motor, then replace with the new
• Reinstall and lock the hopper
• Pass the power cord through hole 1 and then lock the ground wire
• Connect the wires and secure them
• Reinstall the service door under the hopper